What is the Water Ozonator?
The Water O3zonator Model# WOZ3 is a true* 108mg/Hr
Corona Discharge (CD) Ozone (O3) Generator used for
Water Ozonation and Oxygenation that is powered by 12 Volts DC. Ozone has powerful
oxidation potential and is used to disinfect, sterilize and oxygenate water.
(Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.)
NOTE: The Ozone generated by The Water O3zonator
is NOT intended to be breathed in! It is intended for water ozonation only. Ozone can be very damaging
(through rapid and powerful oxidation) to sensitive lung tissues. Always use The Water O3zonator
in a well ventilated area. A stove-top exhaust fan works well to remove the off gas of The Water O3zonator
unit.
NOTE: The WOZ3 unit's output ozone concentration is below permissible levels
(<0.05 PPM) at a distance greater than 48" from unit.
NOTE: Exposure levels of Ozone in air at 0.1 ppm can be tolerated for up
to 8 hours before being considered a hazard. With the WOZ3, the Ozone reading in the air is 0.1 ppm
and less, 24” from the source. At 48” from the source, the reading is 0.06 ppm and
less.
NOTE: The WOZ3 unit is not a medical grade ozone generator. Medical grade
ozonators usually cost 5-10 times more than even excellent quality, non-medical
ozonators like the WOZ3. Because this model WOZ3 ozonator does not incorporate
medical grade components, it is recommended that you do not attempt to feed pure
oxygen (O2) into the chamber. This caution applies to
any ozone generator on the market that does not have medical grade parts and
conponents throughout.
Representing a significant advancement in ozone generation design. The next generation ozonator. The
Water O3zonator Model WOZ3 is a highly efficient,
Fused Quartz Crystal, High Frequency Corona Discharge (CD) ozone generator utilizing
inventor-genius Nicola Tesla's principles. Breakthrough technology has been applied
to the WOZ3 allowing it to operate from a 12 Volt DC power source like an automobile
battery or appropriate solar panel. The WOZ3 unit is complete with a built-in Air
Pump.
The WOZ3 outputs a true* 108mg/Hr. (*Measured with a GM Anceros ozone-in-air analyzer. Many manufacturers
measure ozone output with the chemical titration method, which gives an incorrectly high reading.
Our WOZ3 would be rated at over 200mg/Hr with this test method.)
Ozone concentration is a maximum of 2.1 Gamma (ug/ml or mg/l) at 0.5 LPM flowrate.
The WOZ3 can ozonate an 8 ounce (250mL) glass of room temperature water in less
than 2 minutes and achieve an ORP (Oxygen Reduction Potential) of over +800mV
(chilled water reaches an outstanding +1,000mV ORP in less than 5 minutes). Water
sterilization occurs at greater than 600mV ORP, thus the WOZ3 exceeds the
requirements for water sterilization.
Using advanced principles of the 1900's inventor-genius Nicola Tesla, brought about
designs for an exclusive, state-of-the-art ozone (O3) generation
unit that incorporates a new and proprietary approach to ozone generation:
Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS).
This results in the WOZ3 requiring less than 1 Amp current at 12 Volts DC to operate both the
Ozone Generator and the built-in Air Pump, allowing for quiet and reliable operation.
The Water O3zonator uses state-of-the-art electronics and a
unique circuit design allowing the unit to be extremely lightweight, portable, powerful,
efficient and able to run off a 12 Volt DC power source like an automobile battery if needed.
The Water O3zonator unit takes less than 3 minutes to achieve
maximum Oxidation Reduction Potential (ORP in mV) in an 8 ounce glass (250 ml) of chilled and
purified water to +1,000mV ORP. For 32 ounces (1 Litre), expect full ORP in less
than 20 minutes (see graph below).
Unique Features
-
O3 rating: True* 108mg/Hr @ 2.0 LPM output (*Measured
with a GM Anceros ozone-in-air analyzer. Many manufacturers measure ozone
output with the chemical titration method, which gives an incorrectly
high reading. Our WOZ3 would be rated at over 200mg/Hr with this
test method.)
-
O3 concentration: 2.1 Gamma (ug/ml or mg/l) @ 0.5 LPM
-
Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output
-
Ozone Tube uses high-grade type 214 Fused Quartz Crystal (99.995% pure quartz crystal)
-
High Frequency Corona Discharge (CD) design for quiet, efficient operation.
-
Built-in Air Pump rated 0.5PSI @ 2.0 LPM
-
Super-lightweight and portable design: Weighs only 3 Lbs (1.3 kgs)
-
Simple operation. Turn the unit on and it's ready to operate.
-
12 Volts DC @ 1 Amp. (Comes with an AC-DC Wall Adapter rated at 12 Volts DC @ 1.5 Amps)
-
Utilizes SOTA's proprietary (inventor-genius Nicola Tesla based)
Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS)
for extremely efficient and reliable operation.
-
Aluminum-free. Absolutely NO aluminum or ceramic alumina (aluminum oxide) used in the ozone path.
-
Ceramic Air Stone: featuring a 90 micron pore diameter, extremely
durable, long lasting, inert and non-toxic, high performance air bubbles. Inlet
pipette is made of Kynar, a highly ozone resistant material used in medical
grade ozonators.
-
Silicone Air Tubing will never harden, crack or kink.
-
Maximum ORP (mV) Saturation: <5 minutes per 8 ounces (250 ml)
chilled and purified water reaches over +1,000mV ORP <20 minutes
for 32 ounces (1 Litre).
|
